SINBO SK 2397 - Manual (Page 11)

fourth zone will light in order, when the water is heated to about 90˚C, all the indicators
from the first zone to the fourth zone will light and two beeps will be heard. After one
minute, all of them will be extinguished.
3. Coffee button (C) (heating water to 80˚C and suitable for brewing coffee)
After plugging the power outlet, press the coffee button once (accompanied by a short
beep) if you want to heat water to 80˚C, the indicators in the third zone will flash, following
the water temperature is increasing, the indicators from the first zone to the third zone
will light in order, when the water is heated to 80˚C, all the indicators from the first zone
to the third zone will light and two beeps will be heard. After one minute, all of them will
be extinguished.
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean
your kettle before use by boiling a full kettle of water twice and then discarding the water.
Wipe the surface with a damp cloth.
NOTE: The max capacity of kettle is 1.5L.
* 360 degrees glass cordless kettle
* Auto lid open function
* Electronic control switch
* Keep warm function
* Stainless steel concealed heating element at jug bottom
* Auto shut-off when water boils, over-heat protector function
* Anti-slip feet at the base
* Detachable filter for easy cleaning
* Capacity:1.5L
* AC 230V 50Hz 2200W
OPERATION OF YOUR KETTLE
1. To fill the kettle, remove it from the power base and open the lid by pressing the open
lid button, fill with the desired amount of water, and then close the lid. Alternatively, the
kettle may be filled through the spout. The water level should not exceed MAX level or
sit below MIN level. Too little water will result in the kettle switching off before the water
has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before plugging the power outlet.
2. Connect the plug into power outlet, all the indicators will flash once and two beeps
will be heard. Position the kettle on the power base, the indicators in the fifth zone will
light, If no any operation within one minute, they will be extinguished.
3. Press corresponding button according to your purpose, after press any button, the
kettle will start to operate.
4. Lift the kettle from the power base and one beep will be heard, then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
- 10 -
KNOW YOUR KETTLE