VEGA VEGAVIB 55 - transistor (NPN-PNP) - Manual (Page 19)

6 Setup
6.1 In general
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
DIL switch for mode adjustment - min./max. (1)
l
Signal lamp (4)
Note:
As a rule, always set the mode with the mode switch (1) before
starting setup VEGAVIB 55. The switching output will change if
you set the mode switch (1) afterwards. This could possibly
trigger other connected instruments or devices.
6.2 Adjustment elements
2
3
4
1
Fig. 12: Oscillator - Transistor output
1 DIL switch for mode adjustment
2 Ground terminal
3 Screwed terminals
4 Control lamp
With the mode adjustment (min./max.) you can change the
switching condition of the transistor output. You can set the
required mode according to the "Function chart" (max. - max.
Function/Configuration
Mode adjustment (1)
VEGAVIB 55 - - transistor (NPN/PNP) 19
Setup
29303
-EN
-070109