VEGA PLICSRADIO R62 Wireless receiving unit - Manual (Page 14)

14
5 Connecting to power supply
PLICSRADIO R62 • Wireless receiving unit (multiple channel)
32970-EN-130228
5 Connecting to power supply
5.1 Preparing the connection
Always keep in mind the following safety instructions:
•
Connect only in the complete absence of line voltage
•
If overvoltage surges are expected, overvoltage arresters should
be installed
Two types of power supply unit are available. You can find detailed
information on the power supply in chapter "Technical data" in the
"Supplement".
The operating voltage of PLICSRADIO R62 is connected with stand-
ard cable according to the national installation standards.
The connection PLICSRADIO R62 - C62 is carried out with standard
two-wire cable with screen
Use cable with round cross-section. A cable outer diameter of
5 … 9 mm (0.2 … 0.35 in) ensures the seal effect of the cable gland.
If you are using cable with a different diameter or cross-section,
exchange the seal or use a suitable cable gland.
5.2 Connection steps, connection to C62
Proceed as follows:
1. Loosen the four screws on the housing socket with an Allen key
2. Remove the mounting plate from the housing socket
Note safety instructions
Select power supply
Select connection cable