VEGA KV 31 Mounting brackets For tubes with ø 50…200 mm (Horizontal sensor mounting) - Manual (Page 5)

2 Mounting
Take note of the operating instructions of the corresponding sensor
MINITRAC and the source holder VEGASOURCE.
Take note of the following mounting instructions:
l
Mount the bracket first, then the sensor and the source holder
l
The arrow cutout in the clamp (source container side) and the
transport lug of the source container must point in the same
direction (A) after mounting
l
Make sure that the two clamps (5 and 8) of the bracket are in
parallel. Do this by measuring the distances between the clamps
l
To avoid injuries, shorten the threaded rods (1) of the brackets to a
suitable length after mounting
Mount the bracket according to the following assembly drawing:
7 6 8
3 1 4 2
5 A
Fig. 3: Mounting bracket with horizontally mounted sensor
1 Threaded rod M10 x 360 mm - 4 pieces
2 Hexagon nut M16 - 4 pcs.
3 Hexagon nut M10 - 16 pcs.
4 Washer for M16 - 4 pieces
5 Clamp - Source holder side (VEGASOURCE 31) - 1 piece
6 Washer for M10 - 8 pieces
7 Hexagon screw M8 - 2 pieces
8 Clamp - Sensor side (MINITRAC) - 1 piece
A Arrow cutout of the clamp and the lug point in the same direction
Operating instructions
Mounting brackets for
horizontal mounting
Horizontal sensor
mounting
Mounting brackets KV 31 • Source holder SE 5
2 Mounting
38481
-
EN
-120228