VEGA VEGAPULS series 60 Electronics module (≥ 2.0.0 - ≥ 4.0.0) - Manual (Page 9)

Proceed as follows:
1 Switch off power supply
2 Unscrew housing cover of the electronics compartment
3 Remove the terminal blocks according to the operating instruc-
tions manual of the respective sensor
4 Loosen the two holding screws with a screwdriver (Torx size T 10
or Phillips size 4)
2
1
5 6 7 8 1 2 + ( ) (-)
Fig. 3: Loosening the holding screws
1 Electronics module
2 Screws (2 pcs.)
5 Pull the previous electronics out by using the pull-out tool.
6 Insert the new electronics module carefully.
7 Insert the two hold screws and tighten them
8 Attach the terminal blocks according to the operating instructions
manual of the respective sensor
9 Screw the housing cover on
The electronics exchange is now finished.
As a rule, the exchange of the electronics must be documented
internally when used in Ex applications.
Electronics module • VEGAPULS series 60 9
4 Mounting
36801
-
EN
-101008