VEGA VEGAPULS 65 (≥ 2.0.0 - ≥ 4.0.0) Profibus PA - Manual (Page 15)

15
4 Mounting
VEGAPULS 65 • Profibus PA
36517-EN-121011
1
Fig. 5: Position of the polarisation level
1 Marking hole
When mounting the VEGAPULS 65, keep a distance of at least
500 mm (19.69 in) to the vessel wall. If the sensor is installed in the
center of dished or round vessel tops, multiple echoes can arise.
These can, however, be suppressed by an appropriate adjustment
(see chapter "Setup").
If you cannot keep this distance you should carry out a false echo
storage before setup. This applies mainly if buildup on the vessel wall
is expected. In this case, we recommend repeating a false echo stor-
age later with existing buildup.
> 500 mm
(19.69")
Fig. 6: Mounting of the radar sensor on round vessel tops
In vessels with conical bottom it can be advantageous to mount the
sensor in the center of the vessel, as measurement is then possible
down to the lowest point of the vessel bottom.
Installation position