Sony DPP--SV77 - Manual (Page 20)

20 GB
3 Loading the print cartridge
To replace the print cartridge
When the print cartridge runs out, the cartridge error indicator lights and
an error message appears on the screen.
Open the cartridge compartment lid, push up the eject lever, remove the used
print cartridge, and then insert a new cartridge.
Notes
•Never put your hand into the cartridge compartment. The thermal head reaches
high temperatures, especially after repeated printing.
•Do not rewind the ink ribbon and use the rewound print cartridge for printing.
Otherwise, proper printing result will not be obtained, or even a breakdown may
occur.
•If the print cartridge does not click into place, remove it and
then re-insert it. If the ink ribbon is too slack to be loaded,
wind the ink ribbon in the direction of the arrow to remove
the slack.
•If the print cartridge is not loaded when you turn on the printer, the cartridge
error indicator lights up.
•When placing the print cartridge on a desk or other surface, stand it vertically so
that dust will not get on the ink ribbon.
•Do not touch the ink ribbon or place the print cartridge in a dusty location.
Fingerprints or dust on the ink ribbon may result in imperfect printing.
•Do not change the print cartridge while operating the printer.
Notes on storing the print cartridge
•Avoid placing the print cartridge in a location subject to high temperatures, high
humidity, excessive dust or direct sunlight
•When you are going to store a partially-used cartridge, store it in its original bag.
cartridge error
indicator
Eject lever