VEGA KV 31 Mounting brackets For tubes with ø 200…400 mm (Horizontal sensor mounting) - Manual (Page 6)

1 Make sure that the two clamps (5 and 8) of the bracket are in
parallel. Do this by measuring the lateral distances between the
clamps.
2 Tighten the nuts of the threaded rod evenly. Keep the tube
diameter and the stability of the tube material in mind. Avoid
deformation of the tube through an overtightening of the mounting
bracket.
If you have the impression that the tube cannot permanently carry
the weight of the mounting bracket, sensor and source container,
mount a suitable support below the mounting bracket.
3 Shorten the threaded rods after mounting to avoid injuries.
If there are gaps or intervening spaces around the installation, provide
protective fences or grids to keep hands away from the dangerous
area. Such areas must be marked accordingly.
Install a protective grid on both sides of the mounting bracket. A sheet
metal cover or a correspondingly shaped plastic sheet can also be
used.
Corresponding holes for screws of size M5 are provided on the
mounting bracket.
Mount the protective grid according to the following assembly drawing:
Install a protective grid
6 Mounting brackets KV 31 • Source holder SE
2 Mounting
41407
-EN
-120228