VEGA VEGABAR 83 Save sensor - Quick setup guide - Manual (Page 14)

14
5 Set up with the display and adjustment module
VEGABAR 83 • Slave sensor for electronic differential pressure
46333-EN-131125
The quick setup for interface measurement is finished.
5.2 Parameter adjustment - Extended adjustment
For technically demanding measuring points, you can carry out
extended settings in "Extended adjustment".
The main menu is divided into five sections with the following func-
tions:
Setup: Settings, e.g., for measurement loop name, application, units,
position correction, adjustment, signal output
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, e.g. on instrument status, pointer, measure-
ment reliability, simulation
Additional adjustments: PIN, date/time, reset, copy function
Info: Instrument name, hardware and software version, date of manu-
facture, sensor features
In the main menu item "Setup", the individual submenu items should
be selected one after the other and provided with the correct param-
eter values.
The following submenu points are available:
In the following section, the menu items from the menu "Setup" for
electronic differential pressure measurement are described in detail.
Depending on the selected application, different sections are relevant.
Information:
Further menu items of the menu "Setup" as well as the complete
menus "Display", "Diagnosis", "Additional adjustments" and "Info"
are described in the operating instructions of the respective master
sensor.
Main menu