Altronix eBridge1PCRTX Data Sheet - Manual

Agency Listings:
• UL/CUL Listed for Information
Technology Equipment (UL 60950-1).
• CE approved.
• C-Tick compliant.
Compliant:
• Incorporates *sloc TM (Security Link over Coax) technology.
Input:
• 24VDC to 56VDC Class 2 power supply
(polarity observed).
Power Consumption (under maximum load):
• eBridge1PCRX: 24VDC/1,500mA, 56VDC/900mA.
eBridge1PCTX (30W): Powered by eBridge1PCRX.
eBridge1PCT (15W): Powered by eBridge1PCRX.
Ethernet:
• Connectivity: RJ45, auto-crossover.
• Wire type: 4-pair CAT5 or better structured cable.
• Distance: up to 100m (328 ft.).
• Speed: 10/100BaseT, half/full duplex, auto negotiation.
PoE compliant to IEEE 802.3af (15W) and PoE+
compliant to IEEE 802.3at (30W) delivered to camera
by eBridge1PCTX. Power provided by eBridge1PCRX
to eBridge1PCTX by PoE protocol.
• Throughput is rated to pass 25mbps of data at
distances up to 1500 ft. With proper headend
equipment this supports Megapixel, HD720, HD1080.
Coax:
• Distance: up to 1,500 ft. for power delivery of coax.
• Connectivity: BNC, RG-59/U or similar.
LED Indicators:
• eBridge1PCRX: Blue - Coax link connection (sloc).
Green - PoE ON. Green - Power ON.
Yellow and Green - (RJ45) IP Link
status, 10/100Base-T/active.
LED Indicators (cont’d):
• eBridge1PCTX: Blue - Coax link connection (SLOC).
Green - PoE from eBridge1PCRX.
Environmental:
• Operating Temperature:
eBridge1PCRX:
15W: -- 4ºF to 113ºF (-- 20ºC to +45ºC).
30W for 24VDC: -- 4ºF to 98.6ºF (-- 20ºC to +37ºC).
30W for 48VDC: -- 4ºF to 113ºF (-- 20ºC to +45ºC).
eBridge1PCTX: --- 4ºF to 120.2ºF (-- 20ºC to +49ºC).
• Storage Temperature:
-- 22º to 158ºF (-- 30º to +70ºC). Humidity: 20 to 85%.
Electrical:
• BTU/Hr.:
- 24VDC: 18.43 BTU/Hr.
- 56VDC: 25.8 BTU/Hr.
Functions:
• Auto detection and protection of legacy
non-PoE cameras/devices.
Applications:
• Retrofit digital IP cameras in an analog CCTV
installation.
• Works with Megapixel, HD720, HD1080 and VGA
(SD) cameras (see note, pg. 2).
• Extend Network link distance in an industrial
environment over 610m (2000 ft.) (see note, pg. 2).
• Upgrade deployed CCTV Coax to a digital network
in Retail, Casinos, Airports, Schools, Hospitals, etc.
Mechanical:
• Dimensions (W x L x H approx.):
eBridge1PCRX:
3.5” x 4.375” x 1” (88.89mm x 111.125mm x 25.4mm)
eBridge1PCTX:
2.5” x 4.375” x 1” (63.5mm x 111.125mm x 25.4mm)
eBridge1PCRTX - IP/PoE over Coax Kit
Rev. DSeBridge1PCRTX_08012013
Specifications
* sloc is a registered trademark of Intersil Corporation.
The eBridge1PCRX and eBridge1PCTX are CAT5 to Coax cable
Ethernet adapters media converters that deliver data and power over
the coax cable in a PoE+ compliant format. The paired set enables fast
10/100Base-T Ethernet digital communication to be transmitted over
Coax cable. An eBridge1PCRX receiver sends power over the coax to
the eBridge1PCTX transmitter under PoE protocol. The eBridge1PCTX
in turn delivers that PoE+ compliant power to a PoE enabled camera or
IP device. The eBridge1PCRX will not deliver power to non compliant
devices, thus avoiding accidental power turn into improperly connected
analog cameras. These plug and play units facilitate system upgrades
from analog to IP cameras/devices utilizing existing legacy Coax and eliminating the costs and labor associated with
installing new network cabling. In addition, data transmission and power over the Coax is possible up to1500 ft. in
comparison to 100m (328 ft.) Ethernet maximum distance. A maximum range from head end to the PoE camera/device
is 610m (2000 ft.) taking into consideration that up to 100m (328 ft.) of structured cable may be deployed at each end.
eBridge1PCRX
and eBridge1PCTX
Overview
Agency Approvals
UL/CUL Listed for Information
Technology Equipment (UL 60950-1).
European Conformity
C-Tick Compliant
Z1409