Altronix PT2724 Installation Instructions - Manual (Page 7)

Enter the holiday date, day of week and year by depressing UP and DWN to
make the selection then depress ENTER to accept.
Note: Holiday events will override all regularly programmed events that occur on a
particular holiday date.
F. Delete/Disable Events or Edit Events:
Select channel A or B by moving slide switch SW3 to appropriate position.
Note: Channel cannot be changed in the middle of programming events. To change channels
you must exit programming then change channel switch position then enter program mode again.
Previously programmed regularly scheduled and/or holiday events may be deleted/
disabled without having to erase all events.
Depress SET until ENTER to
SET EVENT
Depress ENTER A01 ON
TU 00:00
Now scroll using UP and DWN push buttons to the event you wish to delete, depress
ENTER to move flashing cursor under relay option then depress UP and DWN push
buttons until DIS is displayed, depress
ENTER to confirm.
G. Delete All Events:
This will delete all previously programmed events.
Depress SET until ENTER to
CLR MEM
Depress ENTER CLEAR
MEMORY?
Depress ENTER PRESS UP
& ACCEPT
Depressing UP push button will now clear all events previously programmed.
If you wish to escape from this selection depress any of the other push buttons:
SET, ENTER and DWN.
H. Tandem Relay Mode:
To operate in the Tandem Relay Mode, close switch SW2. This mode setting will allow
events programmed for Channel A and Channel B to operate both relays simultaneously
(1 DPDT relay output). This setting doubles the amount of programmable events.
Note: When using the Tandem Relay mode, sequential ON/Off or OFF/ON events must be
programmed in the same channel. (If there is a Channel Program conflict, such as CH A is
set to ON and Channel B is set to OFF. The ON command will override the OFF and both
relays will remain ON.
- 7 -
appears in display.
will appear in display.
will appear in display.
appears in display.
appears in display.
>