Altronix RE2 Installation Instructions - Manual

RE2 - Rack Mount Battery Enclosure
BAT4
+ + --- ---
24VDC
Power Supply/Charger 1
Battery Terminals
24VDC
Power Supply/Charger 1
Battery Terminals
24VDC
Power Supply/Charger 2
Battery Terminals
BAT3
+ + --- ---
BAT2
+ + --- ---
BAT1
+ + --- ---
BAT2
+ + --- ---
BAT1
+ + --- ---
BAT2
+ + --- ---
BAT1
+ + --- ---
BAT4
+ + --- ---
12VDC
Power Supply/Charger
Battery Terminals
12VDC
Power Supply
Charger 1
Battery Terminals
12VDC
Power Supply
Charger 2
Battery Terminals
BAT3
+ + --- ---
BAT2
+ + --- ---
BAT1
+ + --- ---
Overview:
Altronix RE2 Rack Mount Battery enclosure offers a convenient way to house up to four (4) 12VDC/7AH batteries
in a rack configuration.
Specifications:
Installation Instructions:
1. Mount RE2 in desired rack location.
2. Remove front access panel by rotating thumb screws counter clockwise remove (Fig. 2, pg. 2).
3. Place desired number of sealed lead acid rechargeable batteries in each slot on the bottom of enclosure
[BAT1-BAT4] (Fig. 2, pg. 2).
4. Connect battery terminals to each pair of Red [+] and Black [--- ] battery leads that correspond to
terminal blocks [BAT1 - BAT4] (carefully observe polarity).
5. Replace the front access panel by rotating thumb screws clockwise (Fig. 2, pg. 2).
6. Connect charging circuit from single power supply or multiple power supplies in desired configurations
[BAT1-BAT4] (carefully observe polarity) (Fig. 1a thru Fig. 1d, below).
Fig. 1
Fig. 1a - Single or multiple 12VDC power supplies.
Fig. 1b - Single 12VDC power supply (parallel connection).
Fig. 1c - Single or multiple 24VDC power supplie (series connection).
Fig. 1d - Single 24VDC power supply (series parallel connection).
• Battery output PTCs rated @ 12 amp.
• Four (4) individual sets of battery power
terminals (external). • 2U rack mount chassis for use in standard EIA 19” rack.