Altronix PD8CB Installation Instructions - Manual

PD8CB - Power Distribution Module
Overview:
The PD8CB power distribution module converts a single AC or DC output into eight (8) PTC protected outputs.
Specifications:
Input:
• 28VAC or 28VDC up to 14 amp.
Output:
• Eight (8) PTC protected outputs (PTC’s are rated @ 2.5 amp).
• Surge suppression.
Visual Indicators:
• Power output LED indicator.
Additional Features:
• Power ON / OFF switch.
Board Dimensions (approximate):
5.25"L x 3.25"W x 1"H
Installation Instructions:
1. Mount PD8CB in desired location/enclosure.
2. Connect the desired power supply output to terminals marked [INPUT] (Fig. 1A).
3. If using DC voltage, left terminal is NEG. (-) and right terminal is POS. (+) (Fig. 1A).
4. Measure output voltage before connecting devices. This helps avoid potential damage.
All terminals with common suffix P 1P, 2P...” are same polarity.
5. Set power switch [SW1] to the OFF position.
6. Connect each device to terminal pairs 1 to 8 marked [1P-1N thru 8P - 8N].
7. Set power switch [SW1] to the ON position.
N
C O M M O N P O W E R O U T P U T S
P
F U S E D P O W E R O U T P U T S
D1
INPUT
R1
LED
SW1
O
N
O
F
F
F 1 F 2 F 3 F 4 F 5 F 6 F 7 F 8
1 2 3 4 5 6 7 8
N P S
M
a
in
F
u
s
e
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056
website: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
IIPD8CB - Rev. 111704
J18J MEMBER
Fig. 1
N
C O M M O N P O W E R O U T P U T S
P
F U S E D P O W E R O U T P U T S
D1
INPUT
R1
LED
SW1
O
N
O
F
F
F 1 F 2 F 3 F 4 F 5 F 6 F 7 F 8
1 2 3 4 5 6 7 8
N P S
M
a
in
F
u
s
e
Neg. (--- ) Pos. (+)
Fig. 1A