Altronix HubWay LD8D Data Sheet - Manual

Altronix HubWayLD8D Active UTP Transceiver
Hub w/Integral Camera Power transmits UTP
video, RS422/RS485 data and power over a
single CAT-5 or higher structured cable. Unit
provides 8 camera channels in a space saving
1U EIA 19” rack mount chassis which may be rack, wall or shelf
mounted. Video transmission range is up to 3000 ft. max. per channel. Units are compatible with AC and/or DC
fixed or PTZ cameras when utilizing Altronix HubWayAv, HubWayDv or HubWayDvi Video Balun/Combiners.
In addition, the unit features individually selectable 24VAC or 28VAC PTC protected outputs with surge suppression.
An optional HubSat4D Passive UTP Transceiver Hub with Integral Camera Power can be used as an accessory
module to transmit video from up to 4 cameras over a single CAT-5 or higher structured cable back to the
HubWayLD8D. In addition, the HubSat4D provides power to these cameras locally to eliminate the possibility of
voltage drop associated with long cable runs.
Input:
• 115VAC 50/60Hz, 1.5 amp
or 230VAC 50/60Hz, 1 amp.
• Primary fuse (internal) is rated at 5 amp/250V.
Video:
• Eight (8) channels of video over twisted pair
up to a distance of 3000 ft. per channel.
• Eight (8) 75 ohm video outputs.
Data:
• RS422/RS485 data inputs.
Power:
• Individually selectable 24VAC or 28VAC power
outputs with OFF position.
• Unit provides up to 1 amp max. per channel not to
exceed a total of 5 amp (150VA) maximum current.
• Class 2 Rated power limited outputs.
• PTC protected outputs are rated @ 1 amp
per channel.
• Surge suppression.
Visual Indicators:
• AC input power indicator.
• Video signal and power LED indicators.
Features:
• Picture and Gain control.
• Illuminated master power disconnect circuit breaker
with manual reset.
• IEC 320 - 3-wire grounded line cord (detachable).
• Unit can be rack, wall or shelf mounted.
• 1U EIA 19” rack mount chassis.
Accessories:
• Optional HubSat4D allows transmission of up to
four (4) video signals over a single CAT-5 or higher
structured cable.
• Video Balun/Combiners:
- HubWayAv - for use with 24VAC cameras.
- HubWayDv - for use with 12VDC cameras.
- HubWayDvi - for use with 12VDC
cameras without isolation.
Shipping Weight (approximate):
- HubWayLD8D: 13.5 lbs.
- HubWayLD82D: 14.7 lbs.
- HubWayLD83D: 14.2 lbs.
HubWayLD8D
Eight (8) Channel Active UTP Transceiver
Hub with Integral Camera Power
HubWayLD82D
Eight (8) Channel Active UTP Transceiver with
eight (8) HubWayAv Video Balun/Combiners
HubWayLD83D
Eight (8) Channel Active UTP Transceiver with
eight (8) HubWayDv Video Balun/Combiners
HubWay ® LD8D Active UTP Transceiver Hub
with Integral Camera Power
Rev. DSHubWayLD8D - E20I
Overview
Specifications
Models
UL Listed for Commercial CCTV Equipment (UL 2044).
Agency Approvals