Altronix RBR1224 Installation Instructions - Manual

RBR1224 - Electronic Toggle/Ratchet Relay
Specifications:
• 12VDC to 24VDC operation.
• Positive (+) or negative (-) ultra sensitive trigger
(3VDC to 24VDC @ 20mA minimum).
• DPDT contacts rated at
2 amp/120VAC/28VDC.
• Relay status LED.
• Remote LED status output.
• Snap track mountable (order part # ST3).
Board dimensions: 3"L x 2.5"W x 1"H
Applications:
• Use with PGM alarm control panel outputs.
• Electronically shunt-alarm zones,
door control or keypads.
• Interfaces with wireless receivers.
• Converts momentary to maintained contacts.
Installation Instructions:
1. Connect aux power to terminals marked [POS (+)] and [NEG (-)].
2. The relay will change state to latch ON or OFF by the application of a positive
momentary trigger voltage to the terminals marked [TRG +] and [POS (+)] or negative
momentary trigger voltage to terminals marked [TRG -] and [NEG (-)].
3. Relay status LED is lit when relay is energized. To use a remote LED. Connect negative
lead of remoted LED, to terminal marked [LED] connect positive lead of LED to [POS (+)].
LED TRG -- NEG (-- ) C NO NC
NC NO C POS (+) TRG +
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056
website: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
IIRBR1224 - Rev. 10803
G14J
MEMBER