Altronix SMP5 Installation Instructions - Manual

SMP5 - 1 -
Overview:
SMP5 power supply/charger converts low voltage AC input into 6VDC, 12VDC or 24VDC @ 4 amp of continuous
supply current (see specifications). This general purpose power supply has a wide range of applications for access control,
security and CCTV system accessories that require additional power.
Specifications:
* Specified at 25˚ C ambient.
Voltage Output/Transformer Selection Table:
Output
Voltage
Switch Position
Transformer Requirements
(Recommended Altronix Part #’s)
SW1 SW2
6VDC Closed/On Open/Off 16VAC / 40VA (TP1640)
12VDC Open/Off Open/Off 24VAC or 28VAC / 100VA (T2428100), or 16VAC / 100 VA (T16100)
24VDC Open/Off Closed/On 28VAC / 175VA (T2428175)
Note: Transformers with higher power (VA) ratings may be used for all output voltages selected above
provided the input voltage does not exceed 28VAC or 45VDC.
Installation Instructions:
The SMP5 should be installed in accordance with The National Electrical Code and all applicable Local Regulations.
1. Mount the SMP5 board in the desired location/enclosure.
2. Set DC output voltage with switches (Voltage Output/Transformer Selection Table).
3. Connect a proper transformer to the terminals marked [AC] (Voltage Output/Transformer Selection Table).
Use 18 AWG or larger for all power connections (Battery, DC output).
4. Measure output voltage before connecting devices. This helps avoiding potential damage.
5. Connect devices to be powered to the terminals marked [+ DC --- ].
6. When the use of stand-by batteries is desired, they must be lead acid or gel type.
Connect battery to the terminals marked [+ BAT --- ] (battery leads included).
Use two (2) 12VDC batteries connected in series for 24VDC operation.
Note: When batteries are not used, a loss of AC will result in the loss of output voltage.
Input:
• 16VAC to 28VAC (Voltage Output/Transformer
Selection Table).
Output:
• 6VDC, 12VDC or 24VDC selectable output.
• 4 amp supply current.*
• Filtered and electronically regulated outputs.
• Short circuit and thermal overload protection.
Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Maximum charge current 0.3 amp.
• Zero voltage drop when switching over to battery backup.
Visual Indicators:
• AC input and DC output LED indicators.
Features:
• Extremely compact design.
• Includes battery leads.
• Snap Trac compatible
(order Altronix model number ST3).
Board Dimensions (W x L x H approx.):
3” x 3.5” x 2” (76.2mm x 88.9mm x 50.8mm)
SMP5 - High Current Power Supply/Charger