Altronix AL624 Installation Instructions - Manual

Overview:
These linear power supply/charger kits have a wide range of applications including: access control, security and CCTV
system accessories that require additional power.
Specifications:
AL62412C/AL62412CX:
• 12VDC @ 1.2 amp continuous supply current.
• Kit includes: power supply, 12VDC 4AH (AL62424CX - 12VDC 7AH) rechargeable battery and 16.5VAC 20VA
Class 2 Rated plug-in transformer.
AL62424C:
• 24VDC @ 750 mA continuous supply current.
• Kit includes: power supply, two (2) 12VDC 4AH rechargeable batteries and 24VAC 40VA Class 2 Rated
plug-in transformer.
Installation Instructions:
1. Mount unit in the desired location/enclosure.
2. Unit is factory set for correct output voltage.
3. Connect wall plug-in transformer to the terminals marked [AC].
Use 18 AWG or larger for all power connections (Battery, DC output).
4. Measure output voltage before connecting devices. This helps avoiding potential damage.
5. Devices to be powered should be connected to the terminals marked [+ DC] and [DC - BAT] carefully observing polarity.
6. Connect battery to the terminals marked [BAT +] and [DC - NEG] (battery leads included).
Note: When batteries are not used, a loss of AC will result in the loss of output voltage.
AL624 Kits - Linear Power Supply/Chargers
Output:
• See below for the specific model.
• Filtered and electronically regulated output.
• Short circuit and thermal overload protection.
Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.
• Maximum charge current 0.3 amp.
• PTC battery protection.
Visual Indicators:
• AC input and DC output LED indicators.
Features:
• Extremely compact design.
• Battery leads included.
Board Dimensions (W x L x H approx.):
2.5” x 3” x 1.5” (63.5mm x 76.2mm x 38.1mm)