Hyundai H-1614 - Manual (Page 4)

4
When you listen to the radio, please turn the knob to adjust it to your desired volume.
Band Selection
In receiving state, press the Band / mode button to choose FM, MW, SW programs.
Manual Search
· Press the Power Switch/Sleep off button to turn on the radio.
· Press the Band /mode button to select the band.
· Press the up tuning/hour button or down tuning/minute button to select your desired station frequency. With each press the frequency varies one step until
the station is found.
Attention:
· Manual searching station mode is fit to search weak signal station.
Automatic Search
· Press the Power Switch/Sleep off button to turn on the radio.
· Press the Band / mode button to select one band of them.
· Keep the up tuning button or down tuning button pressed, when you see the display frequency automatically change, release the button, when there is a
station, it will stop searching automatically.
· In the course of automatic searching, press the up tuning/hour or down tuning/minute button, to stop searching.
Attention:
· Automatic searching station mode is fit to search strong signal station.
· In the course of automatic searching, if the digit on the display screen varies slowly, it means that there is weak signal station nearby, you can change to
use manual to search station.
Frequency Change Law
· Receiving FM, press the up tuning/hour or down tuning/minute button once, the frequency increases or decreases 0.1 MHz.
· Receiving SW, press the up tuning/hour or down tuning/minute button once, the frequency increases or decreases 0.005 MHz.
· When receiving MW, press the up tuning/hour or down tuning/minute button once, the frequency increases or decreases 9KHz.
Memory Stations
· Tune the desired station with auto or manual search.
· Press the memory/time set button, the "MEMORY" is flashing on the display screen.
· Press the Memory + or the Memory - to select stored address. In 5 seconds press the memory/time set button again to confirm the stored address, the
station frequency has been stored in the address.
Attention:
You can store 10 stations in each band. If in 1-10 address the station frequency already exists, store new frequency according to the above-mentioned
methods, the old frequency will be cancelled.