Hyundai H-1617 - Manual (Page 4)

4
Turning On/Off
Plug the power cord into a wall outlet.
Locate the POWER switch on the rear panel and set it to the ON position.
Press the VOLUME/POWER knob on the front panel to turn the unit on.
RC Battery Installation
Insert 2 x “AAA” size batteries into the battery compartment. Be sure that the batteries are inserted correctly to avoid damage to the RC. Always remove the
batteries when the RC will not be used for a long period of time, as this will cause leakage to the batteries and subsequently damage to your set.
Notes: Use batteries of the same type. Never use different types of batteries together. If the distance required between the RC and the unit decreases, the
batteries are exhausted. In this case replace the batteries with new one.
Radio operation
Automatic tuning
Press the FUNCTION button to select “TUNER” mode.
Press the BAND/TAG button to select AM or FM.
Press the NEXT or PREV button to start automatic tuning process.
Manual tuning
It is intended for selecting stations, which cannot be tuned automatically (manual selection). To tune a channel manually:
Press the FUNCTION button to select “TUNER” mode.
Press the BAND/TAG button to select AM or FM.
Shortly press the NEXT or PREV button (0.5 second or less), the frequency changes by a fixed step: FM: 0.05 MHz steps/AM: 9 kHz steps.
Memory preset
After performing automating tuning, press the MEMORY button to start the preset process.
Display will show the memory sequence number and a flashing “1”.
Press the PRE-UP or PRE-DN button or the MEMORY button of the front panel to determine the preset station number.
Press again the MEMORY button to preset your desired station.
Once all the stations were preset, press the PRE-UP or PRE-DN button to listen to your desired station.
Mono/Stereo
Press the MONO/ST. button to achieve the best frequency.