C&H Technology 60-70MT..KPbF Series - Manual (Page 3)

www.vishay.com For technical questions, contact: [email protected] Document Number: 94356
2 Revision: 29-Apr-08
60-70MT..KPbF Series
Vishay High Power Products Three Phase Bridge
(Power Modules), 60/70 A
FORWARD CONDUCTION
PARAMETER SYMBOL TEST CONDITIONS 60MT.K 70MT.K UNITS
Maximum DC output
current at case temperature
I
O
120° rect. conduction angle
60 (75) 70 (90) A
85 (61) 85 (57) °C
Maximum peak, one-cycle
forward, non-repetitive
surge current
I
FSM
t = 10 ms No voltage
reapplied
Initial
T
J
= T
J
maximum
420 480
A
t = 8.3 ms 440 500
t = 10 ms 100 % V
RRM
reapplied
350 400
t = 8.3 ms 370 420
Maximum I 2 t for fusing I 2 t
t = 10 ms No voltage
reapplied 870 1150
kA 2 s
t = 8.3 ms 790 1050
t = 10 ms 100 % V
RRM
reapplied
610 800
t = 8.3 ms 560 730
Maximum I 2 √t for fusing I 2 √t t = 0.1 to 10 ms, no voltage reapplied 8700 11 300 A 2 √s
Low level value of threshold voltage V
F(TO)1
(16.7 % x π x I
F(AV)
< I < π × I
F(AV)
), T
J
maximum 0.85 0.86
V
High level value of threshold voltage V
F(TO)2
(I > π x I
F(AV)
), T
J
maximum 1.07 1.08
Low level value of forward slope resistance r
f1
(16.7 % x π x I
F(AV)
< I < π × I
F(AV)
), T
J
maximum 8.04 7.35
m
Ω
High level value of forward
slope resistance
r
f2
(I >
π x I
F(AV)
), T
J
maximum 7.08 6.53
Maximum forward voltage drop V
FM
I
pk
= 100 A, T
J
= 25 °C, t
p
= 400 µs single junction 1.75 1.55
V
RMS isolation voltage V
ISOL
T
J
= 25 °C, all terminal shorted
f = 50 Hz, t = 1 s
4000
THERMAL AND MECHANICAL SPECIFICATIONS
PARAMETER SYMBOL TEST CONDITIONS 60MT.K 70MT.K UNITS
Maximum junction operating and
storage temperature range
T
J
, T
Stg
- 40 to 150 °C
Maximum thermal resistance,
junction to case
R
thJC
DC operation per module 0.37 0.29
K/W
DC operation per junction 2.22 1.75
120° rect. conduction angle per module 0.40 0.34
120° rect. conduction angle per junction 2.42 2.01
Maximum thermal resistance,
case to heatsink per module
R
thCS
Mounting surface smooth, flat and greased 0.03
Mounting torque ± 10 %
to heatsink A mounting compound is recommended and
the torque should be rechecked after a period
of 3 hours to allow for the spread of the
compound. Lubricated threads. 4 to 6
Nm
to terminal 3 to 4
Approximate weight 176 g