Atdec Visidec VF-M Installation manual - Manual

A Component Checklist - Check you have received all parts against the component checklist prior to installing
Installation Instructions
Pole Assembly
5mm Allen
Key
User
Operating
Card
(See note at top
of page)
IMPORTANT:
The “User Operating
Card” must be left
with Visidec Focus
Micro once installed
Bottom
Top
Bits Box
Bolt Through
Base Steel Washer
M8x30mm
Screw
Cable Clip
2mm Allen
Key
Display Mounting
Screws
M4x16mm
(x4)
M4x12mm
(x4)
M4x10mm
(x4)
Desk Clamp Box
5mm Allen
Key
Desk Clamp Bracket Pressure Plate
M8 Desk
Clamp Screw
Bolt Through
Steel Washer
Bolt Through Base
M8 Desk Clamp Screw
(found in the Desk
Clamp Box)
5mm Allen Key
9mm (³/
8
”) Hole
Drill a 9mm (³/
8
”) hole in the work
surface at the desired position and
assemble as shown below.
Work Surface
Pole
Assembly
Step 3: Adjust the height of the Pressure Plate to suit the
work surface and tighten firmly in the desired location.
5mm Allen Key
Tighten Firmly
Desk Clamp
Pole Assembly
OR B1 B2
Step 1: Attach the Desk Clamp Bracket
to the bottom of the Pole Assembly using
the M8x30mm Screw. Tighten firmly
using the 5mm Allen Key. Ensure the
Visidec logo is facing the front as shown.
M8x30mm
Screw
Bottom
Bottom
Step 2: Install the M8 Desk Clamp
Screw and Pressure Plate as shown.
Desk
Clamp
Bracket
5mm
Allen Key
Bolt Thru
Base
Pole
Assembly
Pressure
Plate
M8 Desk
Clamp Screw
5mm
Allen Key
NOTE: It is recommended that the Pole
Assembly be clamped to the rear or side
edge of the work surface
Suits 12mm (½”)
to 38mm (1½”)
thick work
surfaces
ADJUSTMENT RANGE
Cable Balls
(x2)
Slot
NOTE:
Ensure the slot in the Pole Assembly faces away from
the user.
It is recommended that the Pole Assembly be mounted
towards the rear edge of the work surface
Tighten
Firmly