Atdec Spacedec SD-AT-DW Installation manual - Manual (Page 4)

adjusting the Display G
As lCD Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility if the mounting hole pattern does not comply with the international VESA standards. Due to
continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 24.10.07
Installation Complete
G.1. adjusting the Ball Joint Resistance
The Spacedec Acrobat Wall Articulated Arm comes factory set to support 6kg displays. Adjust the arm to suit the
weight of your display as shown in the following steps:
Depending on the weight of the display, it may be
necessary to make adjustments to the Ball Joint
Mechanism. If the display doesn’t hold its position or
is too resistant, adjust the four tension screws located
around the Ball Joint (see diagram on the right) using
the supplied 2.5mm Allen Key.
Check the display, and then adjust again if necessary.
NOTe: Be sure to adjust screws evenly.
Tighten
Loosen
Tension
Screws (x4)
Ball Joint
2.5mm
Allen Key
It is possible to control the amount of resistance in the
Pivot Head to suit your display.
To increase the resistance of the Pivot Head to suit
heavier displays, use the 5mm Allen Key supplied in the
Desk Clamp Box to tighten the interscrew in a clockwise
direction.
To decrease the resistance of the Pivot Head to suit lighter
displays, loosen the interscrew in an
anti-clockwise direction.
NOTe: It is recommended the pivot Head
be left at the factory setting for best
performance.
Pivot Head
Interscrew
5mm Allen Key
Loosen
Tighten
G.2. adjusting the pivot Head Resistance
G.3. adjusting the articulated arm/Gas Strut Resistance
3kg
Display
9kg
Display
Arm
raise Gas
Strut to suit
lighter display
5mm
Allen key
Gas Strut Lighter
Heavier
lower Gas Strut to
suit heavier display
G.3.1. Depending on the weight of the display, it
may be necessary to adjust the arm. This can be
done by using the 5mm Allen Key supplied in the
Desk Clamp Box.
G.3.2. If the arm tends to automatically rise or fall
when the display is attached, it will be necessary
to make small adjustments to the gas strut. (see
diagram on the right)
G.3.3. If the arm tends to rise, the gas strut position
should be raised. If the arm tends to fall, the gas
strut position should be lowered.