Atdec Telehook TH-VA-2x2-NECX463 Installation manual - Manual (Page 3)

Rev.02-06/25/12
Figure 6
Figure 7
Re-place the frame on the wall then secure using the provided hex
nut and flat washer. Hand tighten hex nut only (Figure 4).
Step 6:
Using a 4 or 5 feet long level plum the frame by adjusting the
adjustable lag bolts on the vertical channels counter clockwise to pull
the frame frontward. Use the provided adjustment wrench to rotate
the adjustable lag bolts. Use the level or straight edge to make the
H-slat horizontally straight by adjusting the adjustable lag bolt closest
to the H-slat (Figure 5).
Step 7:
Once the frame is plummed and level tighten the hex nuts
permanently.
Step 8: Install Brackets to Media Player
Attach the media player brackets to the sides of the media
player using its existing side screws (Figure 6).
Step 9: Install Media Player
Choose and remove the bottom left or right lower H-slat frame by
unscrewing its flat head screws (Figure 7). Install the media player to
the wall between the two vertical channels using the appropriate fasteners
through the media player’s brackets (Figure 7). Re-install the bottom
lower H-slat.
Figure 4
Figure 5