Scarlett SC-4009 - Manual (Page 2)

2
DESCRIPTION
1. On/Off/Auto switch
2. Sleep button
3. Alarm Set / Off button
4. Time set button
5. Snooze button
6. Hour button
7. Minute button
8. Volume control regulator/Alarm
9. Band switch
10. Tuning control knob
11. Dial lens
12. AUTO indicator
IMPORTANT SAFEGUARDS
· CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Prefer
servicing to qualified service personnel.
· DANGEROUS VOLTAGE: Uninsulated dangerous voltage that may be of sufficient
magnitude to constitute a risk of electrical shock to persons is present within this product
enclosure.
· ATTENTION: The owner s manual contains important operating and maintenance
instructions for your safety, it is necessary to refer the manual.
POWER SUPPLY
BATTERY OPERATION
· Connect a 9 volt (006P) battery (not included) to the terminals inside the battery
compartment. The battery back-up system is only meant to be used from short temporary
power failures. This enables you to move the set from place to place without re-setting the
clock every time. The clock display will not light up, as well as radio will not work, as the
clock time will be held in the clock memory by the battery back-up system. For longer
durations the battery may become exhausted or there may be some deviation in accuracy.
· When the battery is exhausted, it should be removed from the set to prevent leakage. If you
do not wish to take advantage of the battery back-up system, your set will work normally
without a battery. However, if disconnected from the mains, the clock figures will flash when
the mains are re-connected and you must re-set the clock as described in the AC Operation
paragraph.
AC OPERATION
· The appliance is for household use only.
· Before the first connecting of the appliance check that voltage indicated on the rating label
corresponds the mains voltage in your home.
· Insert the plug into the power supply.
· The set is now working as an electronic clock and it will flash the clock figures to show you it
is not set correctly.
· To set the correct time, press the Time set button and Hour button simultaneously, release
the buttons approximately before the correct time is reached. Now press the Minute button
and Time set buttons simultaneously to set the readout to the correct time precisely.
1
2
3
4 5 6
7
8
9
10
11 12