Atdec Levitate L-PW Installation manual - Manual

Step 2. Fasten Base to Work Surface - Choose DESK CLAMP OR BOLT THROUGH option (PTO...)
Component Checklist
A - DESK CLAMP
The default base setup allows 360° of
rotation of the Lower Arm around the base. If
you want to limit the Lower Arm rotation to
180° go to A1, if not skip to A2.
A1. OPTIONAL 180° ROTATION
To limit the Lower Arm rotation to 180° insert
the Brake Pin underneath the Desk Clamp.
Brake
Pin (x1)
5mm Allen
Key (x1)
2mm Allen
Key (x1)
Spacer
Bush (x4)
45mm/60mm
Bolts (x1 each)
Security
Washer (x1)
Head
Cap (x1)
Security
Screw (x1)
Bolt Through
Washers (x3)
M4 x 12mm (x4)
M4 x 16mm (x4)
M5 x 12mm (x4)
M5 x 16mm (x4)
Mounting
Head
Cover Plate
Base Plate
Display Mounting Screws (BAG B)
Hardware (BAG A)
Arm Assembly
(with pre-assembled Desk Clamp)
Tools Required:
Phillips Head Screwdriver
Power drill
8mm ( 5 /
16
”) drill bit
IMPORTANT INFORMATION
!
IMPORTANT - Install Levitate Single Monitor Arm as per Installation Instructions
! This product supports a maximum weight of 9kg (19.5lbs).
! This product supports VESA mounting hole configurations 75 x 75mm and 100 x 100mm.
! The manufacturer accepts no responsibility for incorrect installation.
Check you have received all parts against the Component Checklist and Hardware.
Step 1. Check Components
L-PB
L-PW
Desk | Single
Installation Instructions
Cable Covers
(x2 sets)
Insert
Brake Pin
PUSH
Desk Clamp
5mm Allen
Key
A2. Position Arm Assembly on the work
surface so that the Desk Clamp hangs over
the edge.
TOP LOADING ATTACHMENT
TIP: When sliding the Desk Clamp
between two work surfaces, ensure
that the Clamp Pad is fully open
and parallel with the edge of the
work surface.
Min. gap=18mm (0.71”)
Work Surface
(top view)
Desk
Clamp
A3. Using the 5mm Allen Key, close the
Desk Clamp to grip the work surface.
Tighten very firmly.
NOTE: The unique top loading Desk Clamp allows product installation/removal
without having to gain access to the underside of the work surface.
A4. Desk Clamp is now installed, please skip to Step 3 (PTO>>>).
The Clamp Pad will automatically
rotate under the work surface
when tightened.
Remove and re-install the Desk Clamp, using
the 5mm Allen Key supplied. Then go to A2.
TIGHTEN VERY
FIRMLY
(clockwise)
Clamp Pad