Atdec Telehook TH-WH-PJ-CM Installation manual - Manual (Page 2)

Centre of
Ceiling Mount
Centre of Gravity
NOTE
If your mounting holes are recessed
into the projector, you may need to use
the additional Spacers supplied in the
Bits Bag. Please select the appropriate
Spacers according to the design of your
projector.
Extension Bracket
Bottom Spacer
Spacer
Recessed Mounting Hole
E.1.
Pick up the projector using both of your index fingers.
Move your fingers along the side of the Projector (follow
Step 1) until it is level. Remember the balance point.
E.2.
Repeat this process for the perpendicular side
(follow Step 2)
E.3.
Where both balance points meet is the Centre of Gravity
of your projector. Use a pencil to mark this point.
Choose the appropriate installation procedure depending on your ceiling type.
Installing the Ceiling Plate C
Finding the Centre of Gravity of the Projector E
Attaching the Ceiling Mount Assembly to the Projector F
Nylon
Anchor
Plug
Centre of Gravity
3mm
Allen Key Extension
Bracket
F.1.
Loosen the M5x10mm Screws using the supplied 3mm
Allen Key until you can slide the extension brackets freely,
as shown.
You may need to replace the attached Extension Brackets
with the additional longer brackets supplied in the package,
to suit the mounting hole configuration of your projector.
F.4.
Select the correct Mounting Screws from the Bits
Bag and firmly screw the Ceiling Mount Assembly
onto your Projector.
Once this is done, the Projector Ceiling Mount
Assembly is ready to be mounted onto the Bottom
Ceiling Hanger.
F.2.
Place the Ceiling Mount Assembly over the Projector and
align the centre of the Ceiling Mount with the Centre of
Gravity marked previously on the Projector.
Step 1
Step 1
Step 2
Step 2
NOTE:
Ensure the
screws are
securely
fixed into the
Timber Beam
Mounting
Plate
Washer
14 Gauge
Coach Screw
Masonry
Ceiling
8mm
( 5 / 16 ”)
Holes
Timber
Beam
20mm
Washer
14 Gauge
Coach Screw
Mounting
Plate
Plaster
Board
3mm ( 1 / 8 ”)
Holes
Tighten
Tighten
Masonry Plaster Board
Attaching the Ceiling Hangers to the Fixing Coupler D
D.1.
Install the Ceiling Hangers to the
required height as shown in the following
diagrams. D.2. D.3.
Bottom
Spacer
Extension
Bracket
Mounting
Hole
Bottom
Spacers
Mounting Screws
Bottom Spacer
F.3.
Place the Bottom Spacers in between the Extension
Brackets and the Projector, and align the mounting
holes as shown below.
Use the recommended mounting
hole pattern shown:
Use the recommended
mounting hole pattern
shown:
Mounting
Plate
Fixing
Coupler
M8x50mm
Socket Head
Cap Screw
6mm
Allen
Key
M8
Nyloc Nut
Top
Ceiling
Hanger
M8
Nyloc
Nut
M8x50mm
Socket Head
Cap Screw
6mm
Allen
Key
Mid Ceiling
Hanger
Bottom
Ceiling
Hanger
M8x50mm
Socket Head
Cap Screw
6mm
Allen
Key M8
Nyloc Nut
Top
Ceiling
Hanger Mid
Ceiling
Hanger
Cable Management
Option
Feed the projector
cables through the
slot on the Bottom
Ceiling Hanger as
shown.
projector
cables
M5x10mm
Socket Button
Cap Screw