Atdec Telehook TH-PF Installation manual - Manual (Page 3)

Step 8. Height Adjustment
Step 9. Insert Security Caps Step 10. Insert Square Nuts
Security Cap
Insert Security Cap and tighten using the supplied 3mm Security Allen Key.
INSERT
Square Nut
Insert one Square Nut to each leg.
Note: if a difference in height of over 7mm is present use the
spacers provided
+ HEIGHT
- HEIGHT
Rotate the dial of the Leg counter-clockwise to increase height and
clockwise to decrease height. If the surface of the projector is uneven the height of the legs can
be adjusted to allow the legs to level with each other by turning
the dial on the leg.
7mm Max.
Studs
1. The four studs on the Base Plate should point along the axis
of the projector.
2. Position the Base Plate centrally towards the heaviest part of
the projector so that the weight of the projector is centred and
balanced after mounting.
Step 11. Base Plate Orientation Step 12. Attach Base Plate
Use the supplied 3mm Security Allen Key to tighten the four screws.
Base Plate
M5x10mm Socket
Head Screw
Square Nut
(inside the Leg)