Atdec Telehook TH-2050-UFL Installation manual - Manual

Component Checklist
Coach Screw (x3)
Nylon Anchor (x3) Washer (x3)
4mm
Allen Key
M4x16mm
M5x16mm
M6x16mm/25mm
M8x16mm/25mm
Installation Instructions TH-2050-UFL
Small-Medium TV Articulated Arm
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
! IMPORTANT - Install Telehook 2050 Small-Medium TV Articulated Arm per Installation Instructions.
! This product supports a maximum load of 25kg (55lbs).
! This product supports VESA mounting hole configurations 200mm wide x100mm high to 400mm wide x 400mm high.
! The manufacturer accepts no responsibility for incorrect installation.
Display Mounting
Screws (x4 each)
Hardware
Tools Required:
Power drill •
4.5mm (0.18”) drill bit •
10.5mm (0.41”) masonry drill bit •
Phillips head screw driver •
10mm (0.39”) socket wrench or shifter •
Step 2. Install Arm/Wall Mount to the Wall
Step 3. Attach Top Caps to the installed Arm/Wall Mount
Top Cap (x2)
Arm/Wall Mount
Mounting Bracket (x2)
Multiwasher (x4)
Timber Stud Wall Masonry Wall
- Drill three 10.5mm (0.41”) diameter holes,
58mm (2.3”) deep.
- Secure the mounting plate to the wall using the Coach
Screws and Nylon Anchors supplied.
- Drill three 4.5mm (0.18”) diameter holes, 58mm (2.3”) deep.
- Secure the mounting plate to the wall using the Coach
Screws supplied.
NOTE: Use a stud finder to accurately locate the centre
of the stud. Ensure that all screws fix securely into stud.
OR
SLIDE
End Cap (x2)
Locking Block (x2)
End Cap Screw (x4)
Coach Screw
Washer
End Cap
Screw
Nylon Anchor
Drilled Hole
End Cap
Coach Screw
Washer
End Cap
Screw
Drilled Hole
End Cap
SLIDE
SLIDE
Top Cap
13mm (0.5”) socket wrench or shifter •