Atdec Spacedec SD-WD Installation manual - Manual

Component Checklist
Step 1. Component Checklist
Check you have received all parts against the Component Checklist above.
Installation Instructions
Wall Mount
Assembly (x1)
Step 2. Installing the Wall Mount Assembly (choose from one of the following options)
For mounting Spacedec to a Timber Stud Wall - Using the Wall Mount Assembly Bracket, mark
the location of the 4 holes and drill using a 4mm drill bit. Secure the bracket to the wall using the M6 Coach
Screws as shown in diagram A.
For mounting Spacedec to a Masonry Wall - Using the Wall Mount Assembly Bracket, mark
the location of the 4 holes and drill using an 8mm masonry drill bit. Secure the bracket to the wall using the M6
Coach Screws and Nylon Anchors as shown in diagram B.
A. Timber Stud Wall B. Masonry Wall
Note: This product will suit VESA compliant monitors with 75mm x 75mm (3” x 3”) and 100mm x 100mm (4” x 4”) hole patterns only.
It will support up to a maximum weight of 25kg (55lbs).
Display | Wall Direct
SD-WD
VESA
plate (x1)
Hardware
Mounting Fasteners
M4x10mm
Screw (x4)
M4x12mm
Screw (x4)
M4x16mm
Screw (x4)
(Optional)
Security
Screw (x1)
M6 Coach
Screws (x4)
Nylon
Anchor (x4)
Combined 3mm
Allen Key and
Phillips-head
Screwdriver (x1)
Wall Mount Assembly
Bracket
M6 Coach
Screw
4 x 4mm
Holes
Wall Material
Stud

TOOLS REQUIRED:
• Power Drill
• Phillips-head Screwdriver
• 4mm ( 3 /
16
”) Drill Bit
• 8mm ( 5 /
16
”) Masonry Drill Bit
• 8mm ( 5 /
16
”) Socket Wrench
or Shifter
Wall Mount Assembly
Bracket
M6 Coach Screw
4 x 8mm
Holes
Masonry Wall
Nylon Anchor