Atdec Telehook TH-VA-2X2-SHARPV6012 Installation manual - Manual

Rev.01-08/11
2 Wide x 2 Deep Video Wall Display (Rear View)
2 Wide x 2 Deep Video Wall Display
This display kit mounts the Sharp PN-V601 LCD
monitors in a 2 wide by 2 deep landscape configuration.
The frame attaches to a wall and receives the LCD
monitors by way of four machined fittings (per monitor)
that thread into the monitor’s VESA holes. These fittings
then insert into the frame’s channels. The monitor’s
fittings secure to the frame with locking arms that provide
an easy way to remove the monitors for service. A
removable panel provides access for media players
behind the frame.
Important: Installing video displays is a serious
endeavor that requires experienced professionals.
Improperly prepared walls and other structures as
well as the equipment being installed can result in
property damage, injury and/or liability to the
installing contractor. Do not proceed if any part of the
installation is in doubt.
Caution: Due to the wide variety of structures,
environments, materials and installation methods, the
installing contractor must exercise good judgment in
selecting the proper mounting area. The mounting
structure must be capable of supporting at least 5 times
the load of the installed equipment. Consult local building
codes for further guidance.
Follow these instructions for the most efficient and
safest mounting results.
Package Contents:
1 pc
2x2 Frame w/ locking arms bracket
16 pcs Phillips flat head screw, M6-25mm long
16 pcs Upper-lower stand-off button (black)
16 pcs Nylon washer spacers, .28IDx .74OD, white
1 pc
Instruction sheet
Notes:
Hardware to mount frame to the wall are not included
Recommended:
Install at least 3 /4” thick plywood to achieve flatness of the wall for installation and to provide an adequate support for the video display.
Note:
The assembled 2x2 frame weighs approximately 85 lb/38.6 Kg and requires at least two installers during lifting.
Installation Instructions
TH-VA-2X2-SHARP601-2
Video Wall 2x2