Atdec Telehook TH-AN-CM Installation manual - Manual (Page 2)

Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 02.03.12©
B Mount your Display
Mount your display onto its wall mount bracket
Connect all the required cables to the display and if necessary, manoeuvre it into its final viewing position
C Installing Cables
Display on
wall mount
bracket
Wall Plate
Install the display’s cables into the left,
right and centre cable bays as shown
F Insert Front Fascia E Attach End Caps
TOP VIEW
Attach an End Cap onto
both ends of the Wall
Plate and secure in place
using the M4 Grub
Screws as shown.
NOTE:
If possible, separate the display’s
power cable from the data cables
(i.e. hi-fi & speaker cables) by
installing them into separate cable
bays. This will reduce the chance of
electromagnetic interference. The
diagram to the right shows an
example installation setup.
Left cable bay
Centre cable bay
(best for display power cable)
Right cable bay
Data cables
(can also be installed
into the same bay)
TOP VIEW
Using two hands,
flex the End Cap
around the
display’s cables
and manoeuvre
them into their
corresponding End
Cap Cable Bay
F.1.
Partially insert the
front facia as shown Front Fascia
TOP VIEW
F.2.
Push the edge of the
Front Facia until it snaps
into place
F.3. Repeat F.2.
down the length
of the Front Facia
until it is firmly
secured onto the
Wall Plate
End Cap Cable Bay
Display Power
cable
A
B
2mm
Allen
Key
M4
Grub
Screw
WARNING: DO
NOT OVER TIGHTEN
Installation Complete
D Insert Cable Clips
Insert the Cable Tabs into
the Wall Plate to Secure
Cables in place.
If required, cables can exit
from the side of the Cable
Manager. In this case, use
the left or right cable bays
only.
Cable
Tab
E.1.
Using your
thumb and
index finger,
flex the Cable
Tab into a
concave shape
E.2.
Twist the Cable
Tabs into the small
slots in the Wall
Plate
Cables exiting from the side