Atdec Telehook TH-3070-UTP Installation manual - Manual

Installation Instructions TH-3070-UTP
Component Checklist
Flat Screen Portrait Wall Mount | Tilt
Rectangular
Washer (x4)
Safety Bar
M6 Coach
Bolt (x6)
Nylon
Anchor (x6)
HARDWARE
Display Mounting
Screws (x4 each)
M5x14mm
M8x20mm/30mm
Tools Required:
• Power Drill
• 4.5mm(0.18”) Drill Bit
• 10mm(0.39”) Masonry Drill Bit
! IMPORTANT - Install Telehook Flat Screen Portrait Wall Mount as per installation instruction.
! This product supports a maximum load of 70kg (154lbs.).
! This product supports Screen Mounting Hole Configurations: From minimum 200mm wide x 200mm high
to maximum 800mm wide x 400mm high.
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received against the component checklist and hardware above.
M6 Washer (x6)
Wall Plate
Step 2. Attach Wall Plate to the Wall
Timber Stud Masonry Wall
NOTE: Use a stud finder to accurately
locate the center of the stud. Ensure
that all screws fix securely into the stud.
Tip: 1. Use a spirit level to align horizontally.
2. Use the Wall Plate as a drilling template.
Coach Bolt
Nylon Anchor
Step 3. Attach Adapter Brackets to Display in Portrait Position
Ø4.5mm x 55mm
deep Drilled Hole
Ø10mm x 60mm
deep Drilled Hole
(Optional) Spacer
Back of Display
Left Adapter Bracket
Washer
Display Mounting Screw
Right Adapter Bracket
M6 Washer
Coach Bolt
M6 Washer
Adapter Brackets (pair)
Big/Small
Spacer (x4/x8)
M6x14mm/30mm
Tension adjustment
knobs should face
outwards
Rounded hooks
should point to the
top of the display