Atdec Telehook TH-1026-CT Installation manual - Manual

Component Checklist
Coach Screw (x4)
Nylon Anchor (x4) Washer 8.5mm(x6)
Washer 4.5mm(x4)
3mm Allen Key
M4x12mm/20mm
M5x12mm/20mm
Installation Instructions TH-1026-CT
Ceiling Tilt Mount
IMPORTANT INFORMATION:
Step 1. Check Components
! IMPORTANT - Install Telehook 1026 Ceiling Tilt Mount per Installation Instructions.
! This product supports a maximum load of 15kg (33lbs).
! This product supports VESA mounting hole configurations 75x75mm and 100x100mm.
! The manufacturer accepts no responsibility for incorrect installation.
Display Mounting
Screw (x4 each)
Hardware
Tools Required:
Power drill •
4.5mm (0.18”) drill bit •
10mm (0.39”) masonry drill bit •
Phillips head screw driver •
12mm (0.47”) socket wrench or shifter •
•
Step 2. Slide Ceiling Mount
Upper Pole Lower Pole Screen Mount Ceiling Mount Upper Pole Bush
Timber Stud Ceiling Masonry Ceiling
Hex-Head Screw
M8x55mm (x2)
Nyloc Hex Nut (x2)
SLIDE INSERT
Ceiling Mount
Upper Pole
Upper Pole Bush
Upper Pole
Insert Bush to the Upper Pole.
Set Screw (x3)
Set Screw
Step 3. Fix Upper Pole
Check you have received all parts against the Component Checklist and Hardware above.
Step 4. Insert Bush
Slide Ceiling Mount on to the Upper
Pole.
Drilled Hole
Nylon Anchor
Ceiling Mount
Washer 8.5mm
Coach Screw
Ceiling Mount
Washer 8.5mm
Coach Screw
- Drill four 10mm (0.39”) diameter holes, 61mm (2.4”) deep.
- Secure the mounting plate to the ceiling using the Coach
Screws and Nylon Anchors supplied.
- Drill two 4.5mm (0.18”) diameter holes, 61mm (2.4”) deep.
- Secure the mounting plate to the ceiling using the Coach
Screws supplied.
NOTE: Use a stud finder to accurately locate the centre
of the stud. Ensure that all screws fix securely into stud.
Fix Upper Pole to Ceiling Mount with
three Set Screws. Tighten using supplied
Allen Key.
M5x6mm
Security Screw
Step 5. Install Ceiling Mount to the Ceiling
OR
Drilled Hole
13mm (0.51”) socket wrench or shifter
J F
H G L E,I
K M
A B
C D