Atdec Telehook TH-3070-CTW-BB Installation manual - Manual

Installation Addendum
TELEHOOK
TH-3070-CTW Back to Back Conversion Kit
C Attaching the Mount to the Ceiling Hanger
TM
IMPORTANT
This Addendum MUST be used
with the Installation Instructions
supplied with Telehook Ceiling
Tilt (TH-3070-CTW)
(1) Follow steps A, B, C on the Telehook TH-3070-CTW Installation Instructions.
(2) Follow step D on Telehook TH-3070-CTW Installation Instructions and repeat for 2nd display.
(3) Follow steps E,F and repeat for 2nd display bracket. Once complete, continue step C below.
M8x10mm
Screw
Swivel Insert
(1) Attach the three Swivel Inserts to the hanger
at the height that has been chosen to mount the
display. (2) Attach the two front collars to the Hanger Pole so that they sit on
the swivel inserts as shown above. Tighten the M8 x 30mm screws so
that the collars are secure on the hanger, however do not over tighten.
Swivel Insert
Collar Front
M8 x 30mm
Screws
Collar Front
B Refer to the Telehook TH-3070-CTW Installation Instructions
A Check Component Checklist and Product Checklist
Ensure you have received all components in both Component Checklist and Product Checklist
WARNING
Failure to follow these installation
instructions and those in the TH-3070-CTW
may result in personal
to Audio/Visual quipment
D Mounting the Display
M8 Small
Washer
M8x45mm
Screw
Hex Tool
Note: The brackets should rest on the
horizontal bar with the slider between
the bracket.
Note: This operation will require two persons
(1) Lift one of the displays with brackets attached and hook the
brackets over the sliders. Hold the display firmly, insert the two M8 x 45mm
screws and tighten firmly using the Hex Tool.
(2) Repeat for 2nd Display
injury and/or damage
Component Checklist
Bits Box
M8 x 55mm
Screw M6 x 12mm
Grub Screw (x3)
3mm Allen Key 6mm Allen Key
Collar Front
M5 x16mm
Mounting
Screws (x6)
M6 x16mm
Mounting
Screws (x6)
M8 x16mm
Mounting
Screws (x6)
M4 x16mm
Mounting
Screws (x6)
5mm Allen Key
M8 x45mm
Locking Screws (x2)
M8 Small
Washer
(x2)
Multi
Washer (x6)
Wall Mount
Horizontal Bar
Slider (x2)
Wall Mount
Bracket (Left) Wall Mount
Bracket (Right)
Product check list:
1 x TH-3070-CTW
(separate product)
1 x Back-to-Back conversion kit