Installation instructions – Atdec Telehook TH-PS-S Installation manual User Manual

Page 2

Advertising
background image

Slide the hook on the Support
Arm over the top bolts on the
Wall Plate.

Swing the Support Arm down so
the bottom slots slide over the
bottom bolts.

Break the Base Cover tab on the side to
allow the cable to exit through slot.

Secure the Base Cover with the
corresponding Security Screws.

Insert cable through Cable Cover and
slide onto the Support Arm.

The Support Arm can be
adjusted by +/- 5° to account
for wall slope or individual
projector characteristics.

Adjust the stop bolt as
shown to maintain the
desired angle.

Secure the position of the Support
Arm by tightening the two bolts on
each side of the Wall Plate.

LH

Step 5. Re-Attach Covers and Cable Cover

Step 4. Attach Support Arm to Wall Mount

RH

+5°

-5°

Ensure there is enough cable length
on either end.

The Cable Cover may need to be cut to length depending on where the projector is positioned along the Support Arm.
After the appropriate length has been attained, slide cover back on. Please refer to your projector documentation for
guidance on Focal Length/Throw.

4.1.

4.3.

4.4.

4.5.

4.2.

5.1.

5.3.

5.2.

Installation Instructions

Advertising