Uncle Milton Spider-Man Web Creator Lab - Manual (Page 2)

2. Place one packet of red or
blue gel into the beaker
and fill with hot tap water
to the top fill line. Wait
until the gel has liquified
(about 5 min.).
3. While you are
waiting for the gel
to liquify, insert the
Web Injector into
the Injection Port at
the center of the
Web Plate.
7. Your web is now ready to go. Fling your red, sticky
webs and web nets and watch them cling to
windows! Stretch and fling your blue webs at
villains! Bounce and splat your web balls!
8. To reuse web gel to make new webs, place the used
web into the beaker. Place the beaker into a bowl
filled with hot water to re-liquify the web gel. Once
the gel has completely liquified, repeat steps 4
through 7.
4. Once the gel has
liquified, remove the gel
packet from the beaker.
With assistance from an
adult, carefully trim the
gel packet with scissors
along the dotted line
and squeeze the gel
into the Web Creator
Lab Injector.
5. Insert the plunger into
the Web Injector and
gradually press
down to inject
gel into the
Web Plate until
the web cavity
is full.
6. Wait 30 minutes for the web
to solidify at room tempera-
ture. Then, open the cover
and slowly remove the
Top Plate. Carefully
remove the web
using the Web
Extractor.
IMPORTANT: ONLY if needed, after reusing web gel five times or more, add ONLY 5 drops of water to the web gel before
re-liquifying to recondition the gel to it’s original sticky formula.
CLEAN UP FOR HAIR, SKIN AND EYES AND ALL OTHER SURFACES NOT MENTIONED BELOW: Rinse with warm water.
Injection
Port
Web
Injector
Frame Lock
Injection Port
Frame Lock Frame Lock
Fill Line
Plunger
Sticky
Web Gel
Web Extractor
CARPET CLEAN UP:
1. Promptly remove excess compound from carpeting.
2. Moisten area with sponge and hot water.
3. As compound softens, remove remaining compound with light
brushing.
4. If stain remains, apply carpet stain remover or rubbing alcohol. Some
light colored carpeting may stain permanently.
FABRIC CLEAN UP:
1. Remove excess compound from fabric.
2. Soak fabric in very warm water or hot water.
3. As compound softens, remove remaining compound.
4. Apply fabric stain remover to area.
5. Machine wash and repeat if necessary. Delicate fabrics (such as cotton)
and whites may stain permanently.
© Marvel
18015-0250-0523-V03
MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2013 UMI. All rights reserved. ® and TM designate
trademarks of Uncle Milton Industries, Inc. © Marvel
MADE IN CHINA
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit unclemilton.com