User manual, Introduction, Safety instructions – Velleman VPA2100MN User Manual

Page 3: General guidelines, Fuse replacement

Advertising
background image

VPA2100MN

V. 03 – 12/04/2013

3

©Velleman nv

USER MANUAL

1.

Introduction

To all residents of the European Union
Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.

Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.

2.

Safety Instructions

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.

Indoor use only. Keep this device away from rain, moisture, splashing and dripping liquids. Never
put objects filled with liquids on top of or close to the device.

Always disconnect mains power when device not in use or when servicing or maintenance activities
are performed. Handle the power cord by the plug only.

Keep the device away from children and unauthorised users.

A qualified technician should install and service this device.

This device falls under protection class I. It is therefore essential that the device be earthed. Have a
qualified person carry out the electric connection.

Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
The device should only be used indoors connected to an alternating voltage of max. 230 VAC/50 Hz.

Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.

Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.

Do not shake the device. Avoid brute force when installing or operating the device.

Select a location where the device is protected against extreme heat, direct sunlight, dust and moisture.
Install it in a well-ventilated area and leave a distance of 30 cm in front of and behind the device for
ventilation.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorized way will void the warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.

4.

Fuse Replacement

Only fit or replace a fuse when the device is unplugged from the mains.
Replace a blown fuse with a fuse of the same type and rating (250 Vac/3.15 A, 5 x 20 mm, order code FF3N):
1. Unscrew the fuse holder cap at the back with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Place the fuse holder back and fasten it with the screwdriver.

Advertising