Velleman PEM300D - Manual (Page 3)

PEM300D
V. 02 – 27/11/2013 3 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer.
2. Safety Instructions
• Make sure that the voltage supply does not exceed the rated value.
• Keep the cables well clear of other current-carrying conductors in order
to avoid the creation of magnetic fields which may cause interference.
• Do not install the sensor where it is exposed to fluorescent lamps with
rapid-starters or high-frequency starters.
• Do not expose the device to dust, water, dirt or oil and protect it from
vibrations or shocks to prevent malfunction.
3. Overview
Refer to the illustrations on page 2 of this manual.
1 Terminals 7 Vertical adjustment screw
(15° up and down)
2 Signal LED (only on receiver) 8 Viewfinder
3 Alarm LED (only on receiver) 9 Horizontal adjustment bracket
(90° left and right)
4 Voltage measuring points
(only on receiver)*
10 Adjustment laser
5 Delay time adjustment knob
(only on receiver)
11 Laser on/off switch
6 Sensor
*There is a power LED to the left of this block on both units