Velleman VDL15RLxA - Manual

VDL15RLxA VELLEMAN 1
VDL15RLxA-series - - ROTATING LIGHTS
1. Introduction
Thank you for buying this rotating light ! Please read the manual carefully before bringing this
device into service.
Make sure that the device was not damaged in transit. If the device is damaged, you should
contact your dealer and postpone installation.
2. Safety Instructions
•
A qualified technician should install and service this device.
•
Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
•
Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications
of this manual.
•
Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
•
There may be some smoke or a particular smell when the device is activated for the first
time. This is normal and any smoke or smell will gradually disappear.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
•
Do not look directly into the light source as sensitive people may go into epileptic seizure if
they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
3. General Guidelines
•
The rotating light should only be used with the supplied power adapter and is designed for
indoor use only.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device will be protected against extreme heat, moisture and dust.
Respect a min. distance of 50cm between the output of the rotating light and the illuminated
surface.
•
Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
Note that all modifications of the device are forbidden for safety reasons. Do not remove the
serial number sticker from the device as doing so will void the warranty.
Protect this device against rain and moisture
Unplug the mains lead before opening the housing