Velleman VDLLMS3 - Manual (Page 2)

VDLLMS3
V. 01 – 27/05/2013 2 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly
before bringing this device into service. If the device was damaged in
transit, don't install or use it and contact your dealer. Damage caused by
disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or
problems. Do not connect the pin spot to a dimmer pack. Refer to the
Velleman® Service and Quality Warranty on the last pages of this
manual.
2. Changing the Lens
Disconnect the pin spot from the mains. Pinch the fixing ring in front of the
lens and remove. Change the lens. Place the fixing ring back over the lens.
3. Technical Specifications
power supply 230 Vac 50 Hz
LEDs 1 x 3 W (CREE)
beam angle 6° or 11° (changeable)
dimensions 97 x 89 x 135 mm
weight 400 g
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device.
For more info concerning this product and the latest version of this
manual, please visit our website www.hqpower.eu.
The information in this manual is subject to change without prior
notice.