M-AUDIO Flying Calf - Manual (Page 5)

5
7. S/PDIF Out: This female RCA jack outputs a standard
S/PDIF digital audio signal. The S/PDIF signal is "stereo,"
containing both left channel and right channel audio data.
The S/PDIF data rate will be determined by the Sample Rate
selector button on the front of the Flying Calf.
Panels - Fig. 1
Installation and Typical Setup
Your Flying Calf box should contain this user manual, a power
adapter and the Flying Calf unit itself. Remove the Flying Calf
and power adapter from the box and plug one end of the power
adapter into the Flying Calf's power jack. With the Flying Calf’s
power button in the “out” position (power off), plug the other
end of the power adapter into a wall socket or power strip. Verify
that the Flying Calf and any other devices you plan to connect to
it, are powered off. Now connect your S/PDIF and analog audio
cables to the Flying Calf.
NOTE: For best results, use a good-quality S/PDIF cable. The
cable should be coaxial with 75-ohm impedance. For example, a
good quality video dubbing cable has these characteristics.
S/PDIF O UT A NALOG I N R L
FLYING CALF A/D
2 0 B I T S / P D I F A / D C O N V E R T E R
P OWER S AMPLE R ATE I NPUT L EVEL
™
48 44.1
R
L
- 60 - 20 - 10 - 6 - 3 C LIP
l
9 VDC
1. 2. 4. 3.
5. 7. 6.
A U D I O TM
24