Velleman VDLPROM2 - Manual (Page 4)

VDLPROM2 Rev. 05
07.05.2013 ©Velleman nv 4
 The mirror ball has to be connected to the motor via the chain. Make sure the motor is installed
perfectly horizontally. There are 3 holes in the base plate for fixation screws.
 Make sure the rotation of the mirror ball is never hampered and that no side forces can impact on the
installation.
 The installation has to be approved by an expert before the device is taken into service.
5. Use
After connecting the devices to the mains, the mirror ball motor will rotate at 3 RPM and the lamp will be
on.
By aiming the spot towards the mirror ball, you will obtain a beautiful, colourful effect.
6. Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location should not be deformed,
modified or tampered with e.g. do not drill extra holes in mounting supports, do not change the
location of the connections, …
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp and the filters (see “4. Installation”).
8. Contact your dealer for spare parts if necessary.
9. Check regularly if the key ring or chain shackles have been deformed. If so, demount the mirror ball
immediately.
7. Technical specifications
PAR-36 Pin Spot
Power Supply
230VAC/50Hz
Power Consumption max. 30W
Dimensions  120 x 160mm
Weight 1,1kg
Lamp PAR-36 lamp [order code LAMP36, LAMP36GE (General Electric)]
Max. Ambient Temperature 45°C
Max. Housing Temperature 100°C
Mirror Ball
Diameter
20 cm (8")
Total Weight 0,980kg
Mirror Ball Motor
Power Supply
230VAC/50Hz
Power Consumption max. 4W
Rotation Speed 3 RPM
Dimensions  110 x 45mm
Total Weight 0,300kg
Maximum diameter of mirror ball 30cm (12")
Maximum load 10kg
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.hqpower.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.