Velleman PCMP30 - Manual (Page 5)

PCMP30
V. 02 – 28/09/2012 5 ©Velleman nv
• For optimal battery life, fully charge the power pack every month, even
if you do not use it.
• Disconnect all devices and cables when not in use.
Charging a USB Device on the Power Pack
1. Important: Before charging a device, make sure that the device input
voltage matches the power pack output voltage. Make sure that the
total load does not exceed the rated output current of the power pack.
See §8. Technical Specifications for information.
2. Caution: Never charge the power pack and use it for charging
other devices at the same time. Disconnect any cables from the
power input port (IN) [1].
3. Connect the USB device that you want to charge to the power output
port (OUT) [4] of the power pack, using your device’s standard USB
cable (not included). See illustration B.
4. Press the on/off button [2] to switch the power pack on and start
charging the device.
Low Battery Alarm
When the power pack’s battery level drops below ±20% while charging a
device, the first LED starts blinking (see illustration C). In that case,
disconnect the device from the power pack and recharge the power pack.
Checking the Power Pack Battery Level
1. Disconnect the power pack from any USB devices.
2. Press the on/off button [2] and wait 5 seconds.
The LEDs [3] now indicate the battery level. See illustration D. The
power pack switches off automatically after 25 seconds.
7. Cleaning and Maintenance
Unplug any cables from the input [1] and output [4] ports before cleaning
or maintenance.
Wipe the device regularly with a soft cloth. Do not use chemicals or
solvents.
8. Technical Specifications
rated input 5 VDC (via micro-USB)
rated output 1 x 5 VDC ~ 1 A (via USB)
built-in rechargeable battery lithium-ion 3.7 V ~ 2600 mAh
accessories USB 2.0 to micro-USB cable
optional PCMP13 (USB 2.0 to iPod/iPad)
dimensions 76 x 34 x 25 mm
weight 95 g
operating temperature 0°C to 45°C