Velleman PROMIX100 - Manual (Page 3)

PROMIX100
V. 1.1 – 12/04/2013 3 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
You have chosen an excellent multifunctional stereo mixer which meets the most stringent requirements for
both home and professional applications. It is equipped with one control function per level allowing all
connected components to be tuned individually. The output display will facilitate your choice of level.
2. Safety Instructions
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
This unit uses potentially lethal voltages. Do not open the cabinet in order to avoid electroshocks.
Do not expose to the sun or other heat sources for any period of time.
Handle the controls with care: avoid rough movements and do not drop or smash the set.
The connections between the mixer and the rest of the equipment should be checked carefully. Faulty
connections or defective shielding may cause buzzing sounds.
3. Front Panel and Controls (Fig. 1)
Refer to the illustrations on page 2 of this manual.
1 POWER switch 9 Input selector for PHONO 1 or LINE1
2 OUTPUT DISPLAY 10 Volume control for PHONO 2 or LINE 2
3 MONITOR switch 11 Volume control for PHONO 1 or LINE 1
4 Monitor LEVEL control 12 Volume control for MIKE 2 and MIKE 4
5 Headphone jack 13 Volume control for MIKE 1 and MIKE 3
6 Volume control for LINE 4 14 6.3 mm jack for MIKE 1
7 Volume control for LINE 3 15 6.3 mm jack for MIKE 2
8 Input selector for PHONO 2 or LINE 2
4. Rear Panel and Controls (Fig. 2)
16 Power supply cable 21 Input jacks L/R PHONO 2 or LINE 2
17 Record output jacks L/R REC 22 Input jacks L/R PHONO 1 or LINE 1
18 Main output jacks L/R AMP 23 6.3 mm jack for MIKE 4
19 Input jacks L/R LINE 4 24 6.3 mm jack for MIKE 3
20 Input jacks L/R LINE 3 25 Earth terminal screw: counters humming sounds.
5. Connections
All connections have to be made correctly in order for the device to work properly.
1. If you wish to turn the device off, simply put the "POWER" switch (1) in the "off" position. All connections
must be established when the device is off. In other words, make sure that all linear controls (4, 6, 7,
10-13) are at zero.
2. Insert the supply cable plug (20) into the current socket.
3. All necessary inputs are connected to cinch plugs through shielded cables. The output jacks are connected
to a stereo unit, also through shielded cables.
4. Microphones: up to 4 microphones can be connected to this mixer through the 6.35 mm plugs (14, 15,
26, 28). Please use a suitable adapter if your microphones are equipped with a different type of plug.
5. Compact disc players, cassette recorders, video recorders, tape recorders and other high level audio signal
sources as well as amplifiers should be connected to the cinch sockets (23, 24).