Velleman VDPC130 - Manual (Page 9)

VDPC130_v3 VELLEMAN 9
• Copying a Scene
o Press and hold the PROGRAM button (11) to enter the programming mode.
o Select the bank in which the scene will be copied using the BANK buttons (15 and 16).
o Select the scene you want to copy using the SCENE buttons (3).
o Press the MIDI / REC button (19) to prepare for copying.
o Select the bank where you desire to copy the scene to using the BANK buttons (15 and 16).
o Press the desired SCENE button (3). All LEDs on the panel will flash.
• Deleting a Scene
o Press and hold the PROGRAM button (11) to enter the programming mode.
o Select the bank in which the scene will be deleted using the BANK buttons (15 and 16).
o Press and hold the AUTO / DEL button (21).
o Select the desired chaser using the CHASER selection buttons (21).
o Press the SCENE button (3) corresponding to the scene to be deleted.
o The scene has been deleted. All the LEDs on the panel will flash. All 240 DMX channels of the deleted scenes
will be set to 0.
• Deleting all Scenes
CAUTION: When you select this function, all programmed scenes will irrevocably be lost.
o Press and hold the PROGRAM button (11) and the BANK DOWN button (16) while disconnecting the device
from the mains.
o Connect the device back to the mains.
e. Sound-controlled Mode
o Press the MUSIC / BANK COPY button (12). The LED will light. When the device receives a sound signal, it
will work in sound-controlled mode.
o Select the bank to be sound-controlled using the BANK buttons (15 and 16).
o You may adjust the fade time using the FADE TIME fader (24).
o Press a CHASER button (22). The chaser will be sound-controlled. You may press more than one chaser to
run them one by one.
o Adjust the duration time using the FADE TIME fader (24).
f. Auto Mode
o To select the auto mode, press the AUTO / DEL button (21) until the LED lights.
o If no CHASER buttons (22) are pressed, it will automatically run a bank. Select the desired bank using the
BANK buttons (15 and 16).
o Press a CHASER button (22). The VDPC130 will automatically run the chaser. You may press more than one
chaser and run them one by one.
o You may adjust the interval time between the scenes using the SPEED fader (23) and adjust the duration time
using the FADE TIME fader (24).
g. MIDI Operation
o Press and hold the MIDI / REC button (19) for about 2 seconds.
o Select the respective MIDI channel (1 ~ 20) using the BANK buttons (15 and 16).
o Press the MIDI / REC button (19) again to save the setting and to exit.