Velleman VDP1001GLD7 User Manual
Page 3
VDP1001GLD7
VELLEMAN
3
VDP1001GLD7 – LASER PROJECTOR – GREEN (7 DMX CHANNELS)
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDP1001GLD7! Please read the manual thoroughly before bringing this device into service.
Carefully unpack your projector and place it on a flat and stable surface. Inspect the device for damage. If the device
was damaged in transit, don't install or use it and contact your dealer. The package should contain: 1 x 3-pin power cord
(3m), 1 x DMX cable (1m) and this manual.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install and service this device.
•
This device is designed for professional use on stage, in discos, theatres, etc. The VDP1001GLD7 should only be
used indoors and connected to an alternating current of max. 240VAC / 50Hz.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
•
Always ground the projector electrically. Failure to do so may damage your projector.
•
There are no user serviceable parts inside.
•
Never operate the projector with missing covers or damaged housing.
•
Never open the housing of the projector. Opening the housing will defeat the interlocks inside the projector and
cause the laser output to stop.
•
Never attempt to bypass the fuses. Always replace defective fuses with fuses of the specified type and ratings.
•
Never cover the aperture with filters or other materials.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Keep the device away from children and unauthorised users.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before servicing, removing or installing the projector.
DANGER! Class IIIB laser product. Avoid direct eye contact with the laser light. Never intentionally
expose eyes to direct laser radiation and do not look at the laser through binoculars, even at a
distance.