Velleman VDPL1000ST - Manual (Page 4)

VDPL1000ST
V. 02 – 26/04/2013 4 ©Velleman nv
 Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
 Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
 Mechanical wear and LEDs are not covered by warranty.
 A qualified technician should install and service this device.
 Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
 This device is designed for professional use on stage, in discos, theatres, etc.
 The device should only be used indoors.
 Use the appropriate power supply (see Technical Specifications below).
 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
 There may be some smoke or a particular smell when the device is activated for the first time. This is
normal and any smoke or smell will gradually disappear.
 Use the original packaging if the device is to be transported.
 Keep this manual for future reference.
4. Features
 very high power output strobe effect, very low power consumption
 indoor use, for all kind of applications
 stand-alone, master/slave, or DMX-controlled
 DMX-controlled via 3 channels (intensity, rate, and duration)
5. Overview
Refer to the illustrations on page 2 of this manual.
1 Bracket 6 Dip switches
2 fuse holder 7 DMX input
3 Powercon in 8 DMX output
4 Powercon out 9 safety hook
5 sensitivity knob
6. Installation
Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
Mounting the Device
 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
 The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
 The installation must always be secured with a secondary attachment e.g. a safety cable.
 Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
 Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
 Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used… Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.