Velleman DVM990BL - Manual (Page 2)

DVM990BL VELLEMAN 1
1. SAFETY INFORMATION
WARNING
To ensure safe operation, and in order to exploit to the full functionality of the
meter, please follow the directions in this section carefully.
This multimeter has been designed according to IEC-1010 for electronic
measuring instruments, with an overvoltage category CAT II and pollution
category 2.
Follow all safety and operating instructions to ensure that the meter is used
safely and is kept in good operating condition.
1.1. PRELIMINARY
1.1.1. When using the meter, the user must observe all normal safety rules
concerning:
•
protection against the dangers of electric current
•
protection of the meter against misuse
1.1.2. When the meter is delivered, check that it has not been damaged in
transit.
1.1.3. If in a poor condition due to harsh storage or shipping conditions,
immediately inspect the meter and confirm its condition.
1.1.4. Test leads must be in good condition. Before using check that the test
lead insulation is not damaged and/or the lead wire is not exposed.
1.1.5. Full compliance with safety standards can only be guaranteed if used
with the test leads supplied. If necessary, they must be replaced with
leads of the same type with the same electric ratings.
1.2. DURING
USE
1.2.1. Never exceed the protection limit values indicated in the specifications
for each measurement range.
1.2.2. When the meter is connected to a circuit under measurement, do not
touch unused terminals.
1.2.3. If the value to be measured is unknown beforehand, set the range
selector to the highest position.
1.2.4. Do not measure voltage if the voltage on the terminals exceeds 1000V
above earth.
1.2.5. Always be careful when working with voltages above 60V DC or 30V
AC rms, keep your fingers behind the probe barriers while measuring.