Velleman LX104 - Manual (Page 4)

LX104/LX105
V. 02 – 18/03/2013 4 ©Velleman nv
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme temperatures. Make sure the ventilation
openings are clear at all times. For sufficient air circulation, leave at least 1” (±2.5 cm) in
front of the openings.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
 Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
 Mechanical wear is not covered by warranty.
 Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
 A qualified technician should install and service this device.
 Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
 This device is designed for professional use on stage, in discos, theatres, etc. The LX104/LX105 can
be used indoors (<35°C, <75%RH) with an alternating current of max. 240V AC/50Hz.
 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
 Use the original packaging if the device is to be transported.
 Keep this manual for future reference.
4. Features
 12 channel in DMX mode for separate control of each LED
 master dimmer and shutter via DMX mode
 built-in programs for stand-alone and sound activated modes
 pulse effect with adjustable speed
 additional power output up to 10 pcs at 230VAC
 truss or floor mounting.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 display 6 DMX input
2 control buttons 7 powerCON in
3 built-in microphone 8 fuse holder
4 sensitivity knob 9 GND
5 DMX output 10 bracket