Velleman MICW50 - Manual (Page 4)

MICW50_v2 HQPOWER 4
4. Description
• Receiver
1. antenna input
2. power switch
3. channel selectors
4. LCD
5. AF volume control
6. balanced XLR output
7. unbalanced ¼” output
8. 15 VDC power input
• Microphone
1. pick-up element
2. power switch
3. LCD
4. channel selector
5. logo
6. battery compartment
5. Setup
• Install the antenna at the rear of the receiver.
• Connect the PSU to the receiver first and then to the mains.
• Connect the receiver to a mixer through the balanced or unbalanced outputs.
• Open the battery compartment of the microphone and install a 9 V battery (mind the polarity).
6. Operation
• Put the volume control on the receiver at the minimum position.
• Switch on the receiver through the on/off switch. Switch on the microphone.
• Select the desired frequency on the receiver through the channel selectors. Select the same frequency on the microphone.
• Gradually increase the volume level. Put the microphone in standby if desired.
7. Important Remarks
• Install the receiver at least 1 m from a wall or the ground for best reception.
• Always switch off both the receiver and the microphone before changing the battery or cleaning. Clean with a dry cloth
only.
• Never open the receiver or the microphone. Opening one of the devices will automatically void the warranty.
• Switch off both the receiver and the microphone after use.